Dialpad Programmin G300 - Nortel Modular ICS 6.0 Installer's Manual

300 / Profiles and Dialpads
Dialpad programming
Use this program to determine how the system will recognize
the characters Q and Z from a set dialpad. The two types of
configurations are called CCITT and non-CCITT.
The default is non-CCITT, where Q and Z are accessed
through the
CCITT systems access these characters through the
á
and (Z) dialpad keys.
To change the setting, follow these steps:
1. Enter the Dialpad access code from a programming set by
pressing
2. Q,Z:0 displays. To change it, press the key below Change.
¨
3. Press
Modular ICS 6.0 Installer Guide
â
d ialpad button.
² ¥ ¥ ë é  ñ ¸  ë
to exit.
à
(Q)
( **3425723).
P0992638 03