Nortel Modular ICS 6.0 Installer's Manual page 311

3. Press
CHANGE
appearances.
¨
4. Press
Tips -
telephone.
In general, auto-answer loop start trunks, auto-answer E&M
trunks and DID trunks are not assigned to telephones. If
assigned, they are used for monitoring incoming call usage, or
for making outgoing calls (auto-answer loop start and E&M
trunks).
In general, fixed data channel trunks are not assigned to
telephones. If assigned, they are used for monitoring call
usage.
You cannot assign a line that is private to another telephone.
Each line assigned to appear at a telephone must appear at a
button with an indicator on that telephone. The maximum
number of line buttons are eight for the M7208 telephone and
T7208 Business Series Terminal, 10 for the M7310 telephone
and T7316 Business Series Terminal, and 24 for the M7324
telephone.
If you set a line to Ring only, incoming calls appear on an
intercom button.
A central answering position (CAP), with one or two CAP
modules, can provide extra line buttons if more than 24 lines
are assigned to the CAP. The remaining lines appear at
buttons on the CAP module. This option is only available on
the M7324 telephone
Tips -
can be assigned any number of lines. Ensure that the lines
assigned to these sets are assigned to ring; otherwise, you
cannot detect incoming calls on the lines.
P0992638 03
and enter the number of target line
to exit or ' to continue programming.
SCAN
Press to view the lines assigned to this
The M7100 and T700 sets have no line buttons and
Terminals&Sets / 311
Modular ICS 6.0 Installer Guide