Table of Contents
Advertisement
416 / System prgrming
Dial Timeout
Dial Timeout (interdigit timeout) specifies how long the ICS
will wait between user-dialed digits. This value allows the ICS
to determine when the user has stopped dialing. The value is
programmed under System progrming, Dialing Plan.
The user can also use the # key to tell the ICS that they are
finished dialing. However, this is not usually required except
for international calls where the number of digits dialed for
country codes varies.
With the display showing System Prgrming
1. Press ≠ then press ' until Dialing
Plan displays.
2. Press ≠ then press ' until Dial
timeout displays.
3. Press CHANGE to select a the timeout value (3, 4, 5, 6, 8, 10,
15) in seconds.
Too small a timeout value forces the user to enter the digits
very quickly one after the other.
Too large a value causes the system to wait for a long time
after the last digit is entered before the call is dialed out.
For more information on non-PRI routing tables and
destination codes, refer to Routing service on page 361.
Access codes
Access codes are used by the system to direct calls to the
correct lines and destinations. If the codes conflict, some of the
features on the system will not work.
The table of default settings can help you plan your access
codes so there are no conflicts.
Modular ICS 6.0 Installer Guide
Installer password required
P0992638 03
Advertisement
Table of Contents
Troubleshooting
