Nortel Modular ICS 6.0 Installer's Manual page 323

Once you create the filters, you can assign the restrictions to a
telephone (Terminals&Sets), to a line (Lines), to a
particular line on a telephone (Terminals&Sets), and to
remote callers (Remote access).
1. Press ≠ and enter the number of the restriction
filter you want to program, or press ' to move
through all the available filters.
2. Press ≠ to see the first restriction in the filter.
The first four digits of the number that will be denied are
included in the display. The full number can be seen by
pressing ≠ again.
3. Use ADD, the dialpad, and OK to program a restriction for
each filter.
4. Press ' when the full restricted number is on the
display (it shows Deny: and the number) to see any
overrides to the restriction.
5. Use ADD, the dialpad, and OK to program overrides for each
restriction filter.
6. Press ANY to enter a wild card character that represents any
digit in a sequence of numbers when denying numbers or
creating overrides.
7. You can press REMOVE to delete a restriction.
The overrides will be deleted as well and the restrictions
will renumber to fill the gap.
P0992638 03
Terminals&Sets / 323
Modular ICS 6.0 Installer Guide