Link At Co (Loop Trunks Only); Aux. Ringer - Nortel Modular ICS 6.0 Installer's Manual

Link at CO (loop trunks only)

Some exchanges respond to a Link signal (
providing an alternative line for making outgoing calls.
• When Link at CO is set to Y (Yes), the system applies the
restrictions on outgoing calls to the digits dialed after the
Link signal, and the call on the alternative line will be
subject to all restrictions.
• Setting Link at CO to N (No) prevents a Link signal from
resetting the Norstar restrictions in cases where the host
exchange does not provide an alternative line.
Press CHANGE to select the setting: Y (Yes) or N (No).
For more information about host signalling options, refer to
Modular ICS 6.0 System Coordinator Guide.

Aux. ringer

This setting allows you to turn the auxiliary ringer on or off.
An auxiliary ringer can be programmed on a line or a set.
When programmed on a set, the auxiliary ringer will ring
every time a call is received. When programmed on a line, the
auxiliary ringer will not ring when a transferred call is
received.
Press CHANGE to select the setting: Y (Yes) or N (No).
Tips -
should be connected by the installer.
If you have an auxiliary ringer programmed to ring for calls
on an external line, and you transfer a call on that line without
announcing the transfer, the auxiliary ringer will ring for the
call transfer.
P0992638 03
The auxiliary ringer is an optional device that
Lines / 343
Installer password required
² à Ú
) by
Installer password required
Modular ICS 6.0 Installer Guide