Paper Lift Plate Horizontal Adjustment; Adjustments For Lu-403 - Konica Minolta DF-606 Service Manual

Field Service Ver2.0 Aug.2005
4.3

Paper lift plate horizontal adjustment

Conduct the paper lift plate horizontal adjustment when a paper feed jam occurs repeatedly or when the lift wire
has been changed.
4.3.1

Adjustments for LU-403

A. Procedure
[7] [3]
[2]
[6]
[4] [8]
[2] [1]
[5]
15ssf3c002na
4. MECHANICAL ADJUSTMENT
1. Turn ON the main power switch (SW1) and the
power switch (SW2) of the main body. After
checking from the operating sound of the paper
lift motor that the paper lift plate has gone up fully,
turn OFF both of the power switches.
2. Remove LU from the main body.
3. Remove the following covers:
• Right cover (See "3.2.2 Removing and rein-
stalling the right cover.")
• Front cover (See "3.2.3 Removing and rein-
stalling the front cover.")
• Rear cover (See "3.2.4 Removing and rein-
stalling the rear cover.")
4. Loosen 2 screws [2] of the adjustment bracket /Fr
[1] and 2 screws [4] of the adjustment bracket /Rr
[3].
5. Using the marking-off line [5] as a guide, adjust
the horizontal level of the paper lift plate [6] with
the adjusting screws [7] and [8].
6. Tighten up 2 screws [2] and 2 screws [4].
7. Reinstall the above parts following the removal
steps in reverse.
Note
• After completion of installation, be sure to
make a print and check to see if a no feed jam
or double feed jam does not occur.
41