Removing/Reinstalling The Stacker Unit (Fs-509) - Konica Minolta DF-606 Service Manual

Field Service Ver2.0 Aug.2005
3.3.9

Removing/reinstalling the stacker unit (FS-509)

Caution
• Be sure to conduct this operation with 2 personnel.
• Be sure to unplug the power cord of the main body from the power outlet.
• Be careful not to let FS fall down when removing FS from the main body and pulling out the
stacker unit from FS. It may cause the injury.
A. Procedure
[3]
[2]
[3]
[2]
[1]
15sff2c016na
[1]
15sff2c017na
1. Remove FS from the main body.
2. Remove the following parts.
• Booklet tray
• Left cover (See "3.3.5 Removing/reinstalling
the left cover")
• Front cover (See "3.3.3 Removing/reinstalling
the front door")
• Rear cover (See "3.3.4 Removing/reinstalling
the rear cover")
3. Disconnect 2 connectors [2] from the relay board
(RB) [1] on the back of the stacker unit.
4. Remove the wiring harness from the 4 clamps [3].
5. Remove the C-clip [1] and the shaft [2], and then
separate the coupling arm [3].
3. OTHER PARTS
43
1