Table of Contents
Advertisement
2. PERIODIC CHECK
2.1.2
Replacing the intermediate transfer roller (sponge roller)
A. Periodically replaced parts/cycle
•
Intermediate transfer roller (sponge roller): Every 500,000 prints
Note
• When replacing the intermediate transfer rollers (sponge rollers), be sure to replace all 2 pairs of
rollers (4 rollers in all).
B. Procedure
[3]
8
[2]
[1]
15sjf2c004na
[1]
15sjf2c005na
Field Service Ver2.0 Aug.2005
1. Open the front door.
2. Remove 2 screws [1] and the bearing [2], and
then remove the shaft of the intermediate transfer
roller [3].
3. Insert a flathead screwdriver into the groove of the
sponge roller [1] and remove the sponge roller by
prizing it open.
4. Reinstall the above parts following the removal
steps in reverse.
Advertisement
Chapters
Table of Contents
