Table of Contents
Advertisement
Field Service Ver2.0 Aug.2005
4.6
Adjusting the mounting position of the alignment plate /Lw (FS-
604)
Conduct this adjustment when there is misalignment in the saddle stitched paper bundle.
A. Procedure
[4]
[3]
[1]
[2]
0
1.5
15sjf3c020nb
4. MECHANICAL ADJUSTMENT
1. Check to see if "4.5.2 Position adjustment for FS-
604" in "4.5 Adjusting the mounting position of
the alignment plate /Up" has been completed.
2. Turn ON the main body and drive the saddle
stitching stopper motor (M18) via the Tech. Rep.
mode.
3. Enter the input check code 76-34 in the I/O check
mode of the Tech. Rep. mode and check to see if
"L" is shown in the display column "IN" (home
position of the alignment plate /Lw).
4. Turn OFF the main body.
5. Open the front door, and then pull out the stacker
unit.
6. Remove 2 screws from the rail stopper, and then
pull out the stacker unit further. (See "4.1 Adjust-
ing the bypass gate.")
Note
• Be sure to place a support under the stacker
unit to prevent FS from falling down.
7. Remove the stapler unit cover. (See "2.3.1
Removing/reinstalling the stapler unit cover (FS-
604 only).")
8. Set the paper that is larger than A4R in the
stacker section, and then make the alignment
plate /UpRr [1] and the alignment plate /LwRr [2]
contact with the paper [3] and check to see if they
are aligned. Also, check to see if the distance A
between the alignment plate /LwRr and the align-
ment plate /LwFr [4] is within the standard value.
Standard value: A = 340.6
(inside to inside)
When the value is not within the standard value,
perform the following adjustment.
+0
mm
-1.5
69
1
Advertisement
Chapters
Table of Contents
