Konica Minolta DF-606 Service Manual page 207

Field Service Ver2.0 Aug.2005
C. Procedure for adjustment when there occurs an irregular skew
[3]
[4]
LU-403
[2]
[1]
[5]
[6]
LU-404
[2]
[1]
15ssf3c005na
4. MECHANICAL ADJUSTMENT
1. Set about 100 sheets of paper in LU (the amount
that does not result in the deformation of the
guide plate).
2. Turn ON the main power switch (SW1) and the
power switch (SW2) of the main body. And after
checking from the operating sound of the paper
lift motor that the paper lift plate has gone up fully,
turn OFF both of the switches.
3. Open the front door and loosen the screw [2] of
the paper width adjustment section [1].
4. Open the upper door and loosen 2 screws [4] of
the guide plate /Fr [3] and 2 screws [6] of the
guide plate /Rr [5].
5. Press the guide plates /Fr [3] and /Rr [5] against
the paper, tighten up screws [2], [4] and [6], 5 in
all.
Note
• The size indication of the guide plate is given
so that it becomes 2 mm larger than the
standard size indication. This clearance of 2
mm may cause a skew depending on the type
of paper.
• When pressing the guide plate against the
paper, be careful not to apply too much force.
Otherwise, the paper feed can be negatively
affected, thus resulting in a jam.
6. Make a consecutive print of the test pattern (No.
16) and check to see if there occurs no skew.
45