Table of Contents
Advertisement
4. MECHANICAL ADJUSTMENT
[3]
[2]
74
[1]
[4]
15sjf3c024na
Field Service Ver2.0 Aug.2005
2. With the power to the main body turned on, con-
duct the I/O check code 75-18: Stapler shift
motor (M11) movement for A4 1-stapling at rear in
the I/O check mode of the Tech. Rep. mode, and
then turn off the power.
3. Open the front door, and then pull out the stacker
unit.
4. Remove 2 screws from the rail stopper, and then
pull out the stacker unit further. (See "4.1 Adjust-
ing the bypass gate.")
Note
• Be sure to place a support under the stacker
unit to prevent FS from falling down.
5. Remove the stapler unit cover. (See "2.3.1
Removing/reinstalling the stapler unit cover (FS-
604 only).")
6. Loosen 2 adjusting screws [1] on the flat-stapling
stopper /Fr and 2 adjusting screws [2] on the flat-
stapling stopper /Rr, and then adjust the positions
of the flat-stapling stoppers /Fr and /Rr by refer-
ring to the markings [3] and [4].
7. Perform the stapling operation and check to see if
the staple position is within the standard value.
Advertisement
Chapters
Table of Contents
