Position Adjustment For Fs-604 - Konica Minolta DF-606 Service Manual

Field Service Ver2.0 Aug.2005
[1]
[2]
4.5.2

Position adjustment for FS-604

A. Procedure
[3]
15sff3c013na
[1]
15sjf3c037nb
4. MECHANICAL ADJUSTMENT
10. Loosen the 2 screws [2] of the alignment plate /
UpFr [1] and adjust the position of the alignment
plate /UpFr so that the distance up to the align-
ment plate /UpRr [3] is within the standard value.
1. With the power to the main body turned on, enter
the I/O check code 76-07 in the I/O check mode
of the Tech. Rep. mode and check to see if "H" is
shown in the display column "IN."
Note
• When "L" is shown in "IN," be sure to open
the front door and pull out the stacker unit
before turning off the power to the main body,
and then conduct Step 2.
2. Move the alignment plate /UpFr [1] manually and
stop it at the position (home position of the align-
ment plate /Up) in which "H" is shown in the dis-
play column "IN."
3. Turn OFF the main body.
4. Open the front door, and then pull out the stacker
unit.
5. Remove 2 screws from the rail stopper, and then
pull out the stacker unit further. (See "4.1 Adjust-
ing the bypass gate.")
Note
• Be sure to place a support under the stacker
unit to prevent FS from falling down.
67
1