Table of Contents
Advertisement
Field Service Ver2.0 Aug.2005
[6]
[8] [7]
[1]
[5]
[9]
16. Remove the E-ring [1].
[4]
[2]
17. Loosen the lift wire /Rr1 [3] by pressing the rear
wire mounting plate /Lt [2] downward and slide
the wire end [4] in the arrow-marked direction for
removal.
Note
• When installing the wire end [4] of the lift wire
/Rr1 [3], be sure to mount it into the installa-
tion hole provided on the outside of the rear
[3]
15swf2c007na
wire mounting plate /Lt [2].
18. Remove the pulley /Rr1 [5] from the shaft and
then remove the lift wire /Rr1 [3].
Note
• When installing it, be sure to wind it 6 turns
around the pulley /Rr1 [5] so that the lift wire /
Rr1 [3] can be pulled out from above the pul-
ley.
• Be careful that the wire does not overlap each
other.
19. Press downward the rear wire mounting plate /Rt
[6] and slide the wire end [8] of the lift wire /Rr2 [7]
in the arrow-marked direction for removal.
Note
• When installing the wire end [8] of the lift wire
/Rr2 [7], be sure to mount it into the installa-
tion hole provided on the inside of the rear
wire mounting plate /Rt [6]. When the wire
end [8] will not get into the installation hole
provided on the inside, be sure to rewind
closely the lift wire /Rr2 [7] that has been
wound around the pulley /Rr2 [9] before
installing it.
20. Remove the pulley /Rr2 [9] from the shaft and
then remove the lift wire /Rr2 [7].
Note
• When installing it, be sure to wind it 6 turns
around the pulley /Rr2 [9] so that the lift wire /
Rr2 [7] can be pulled out from above the pul-
ley.
• Be careful that the wire does not overlap each
other.
3. OTHERS
33
Advertisement
Chapters
Table of Contents
