Table of Contents
Advertisement
Field Service Ver2.0 Aug.2005
2.1.5
Replacing the feed clutch (CL101) and the pre-registration clutch (CL102)
A. Periodically replaced parts/cycle
•
Feed clutch (CL101): Every 3,000,000 prints (once for every 3,000,000 prints for actual replacement cycle)
•
Pre-registration clutch (CL102): Every 3,000,000 prints (once for every 3,000,000 prints for actual replace-
ment cycle)
B. Procedure
[2]
[3]
[1]
[6]
[5]
[1]
15ssf2c012na
[7]
[2]
[4]
[1]
15ssf2c013na
1. Remove the upper door. (See "3.2.1 Removing
and reinstalling the upper door.")
2. Remove 3 screws [1] and then remove the clutch
cover [2].
3. Remove 2 connectors [1].
4. Remove C-clips [2], 1 each, and then remove the
feed clutch (CL101) [3] and the pre-registration
clutch (CL102) [4].
Note
• When reinstalling it, be sure to install it by
engaging the stoppers [5] of the clutch with
the screw [6] or the metal frame [7].
5. Reinstall the above parts following the removal
steps in reverse.
2. PERIODIC CHECK
11
Advertisement
Chapters
Table of Contents
