Konica Minolta DF-606 Service Manual page 204

4. MECHANICAL ADJUSTMENT
4.3.2 Adjustments for LU-404
A. Procedure
[4]
[5]
[1]
[5]
42
[7] [2]
[6]
[3]
15swf3c003na
Field Service Ver2.0 Aug.2005
1. Turn ON the main power switch (SW1) and the
power switch (SW2) of the main body. After
checking from the operating sound of the paper
lift motor that the paper lift plate has gone up fully,
turn OFF both of the switches.
2. Open the upper door.
3. Loosen 2 screws [1] on the front side and 2
screws [2] on the rear side.
4. Using the marking-off lines [3] and [4] as a guide,
adjust the horizontal level of the paper lift plate [5]
with the adjusting screws [6] and [7].
5. Tighten up 2 screws [1] and 2 screws [2].
6. Reinstall the above parts following the removal
steps in reverse.
Note
• After completion of installation, be sure to
make a print and check to see if a no feed jam
or double feed jam does not occur.