4. MECHANICAL ADJUSTMENT
[4]
[1]
34
2. Open the open/close cover [1].
3. Loosen the screw [2] and release the fixing of the
[2]
registration roller bracket [3].
4. According to the original skew pattern, move the
registration roller bracket [3] by 1 division [4] in the
[3]
following direction.
In the case of the pattern A: Move the registration
roller bracket [3] to the lower side (direction down
towards original feed flow).
In the case of the pattern B: Move the registration
roller bracket [3] to the upper side (direction up
towards original feed flow).
5. Repeat the steps 2 to 4 until the original skew is
within the specification (0.5% or less).
Specification: Paper skew ±0.5% or less (paper
skew against the side parallel to the paper feed
direction)
15saf3c001na
Field Service Ver1.0 Jun.2005