Konica Minolta DF-606 Service Manual page 42

4. MECHANICAL ADJUSTMENT
[6] [1]
[4]
[3]
[3]
[4]
[2]
38
[7]
[2][8]
[5]
15saf3c007na
[5]
[1]
15saf3c008na
Field Service Ver1.0 Jun.2005
5. Rotate the sensor holder [1] up to 180º from side
to side and fasten it with 2 screws [2].
Reference
• When tilting the sensor from directly above up
to 10º forward or backward:
Install the sensor holder to the attaching hole
[8] with the projection [3] placed on the side
opposite to the triangular mark ( ) [6]. In this
way, the sensor can be tilted to 10º forward.
And installing the sensor holder to the attach-
ing hole [7] with the projection [3] placed on
the triangular mark ( ) [6] side allows the
sensor to be tilted 10º backwards. In either
case, install the sensor on the side [5] with no
projection [3].
• When installing the sensor turned directly
upward:
With the projection [3] put on the triangular
mark ( ) [6] side, install the sensor holder [1]
to the attaching hole [8]. Install the sensor on
the side [4] provided with the projection [3].
6. Install the sensor [3] to the sensor holder [4] so
that the sensor face [1] gets into the sensor win-
dow [2] as seen from above the original feed tray.
Note
• Be sure to check to see if the sensor [3] is
securely held by the claw [5].
• Be careful that the sensor face [1] does not
get damaged, and also be careful not soil it
with grimy hands.
7. Reinstall the above parts following the removal
steps in reverse.