Table of Contents
Advertisement
4. MECHANICAL ADJUSTMENT
4.2
Paper size sensor sensitivity adjustment
Conduct this adjustment if the punch hole position on the paper is misaligned from the center of the paper to
either the front side or the back side.
A. Procedure
[2]
[3]
[2]
10
[1]
15kjf3c004na
[1]
15kjf3c005na
Field Service Ver1.0 Jun.2005
1. Check to see if FS is connected with the main
body.
2. Open the front door.
3. Remove the screw [2], and then remove the
punch drive board cover [1].
4. Turn ON the main body.
5. Fully rotate the volumes [3] of the punch drive
board (PDB) [1] clockwise, and then rotate each
volume counterclockwise until the corresponding
LED [2] turns ON.
6. Conduct the step 5 for each 5 volumes.
7. Turn OFF the main body.
8. Reinstall the above parts following the removal
steps in reverse.
Advertisement
Chapters
Table of Contents
