Replacing The Stapler Unit (Fs-604) - Konica Minolta DF-606 Service Manual

2. PERIODIC CHECK
2.3.3

Replacing the stapler unit (FS-604)

Note
• The stapler unit consists of the clincher section and the stapler section.
• Never move the clincher section and the stapler section in the horizontal direction manually.
Otherwise, it may cause the timing belt skipping.
• After the reinstallation, be sure to adjust the stapler position in the vertical direction. (See "4.9 Sta-
pler vertical position adjustment (FS-604).")
A. Spotted replaced parts/cycle
• Stapler unit: Every 200,000 staples
B. Procedure
[1]
16
1
[2]
[2]
15sjf2c011na
Field Service Ver2.0 Aug.2005
1. Turn ON the main power switch (SW1) and the
power switch (SW2) of the main body.
2. Specify A4 and the 2-staple mode (flat stapling).
3. Turn OFF SW2 and SW1 in turn.
4. Open the front door.
5. Pull out the stacker unit and remove the stapler
unit cover. (See "2.3.1 Removing/reinstalling the
stapler unit cover (FS-604 only)."
6. Remove 4 screws [2] of the saddle stitching stop-
per motor mounting plate [1] and slide the mount-
ing plate one screw hole space or so to the right.