Adjustment/Setting; Mechanical Adjustment; Pi Displacement Adjustment (With Pk-502 Installed) - Konica Minolta DF-606 Service Manual

Field Service Ver1.0 Jun.2005

ADJUSTMENT/SETTING

4. MECHANICAL ADJUSTMENT

4.1

PI displacement adjustment (with PK-502 installed)

Conduct this adjustment when the punch position is displaced when feeding from PI.
NOTE
• In the PI displacement adjustment, adjust the tray /Up, and then adjust the tray /Lw.
• If the slide distance of the side guide plate /Rr is too long, perform the cover sheet tray size
adjustment in the Tech. Rep. mode, and then perform the procedure from step 2.
A. Procedure
[2]
[1]
1. Check to see if the PK punch hole vertical position
[3]
adjustment is completed by feeding the paper
from the manual feed tray of the main body.
2. Perform the displacement adjustment for the main
body trays 1, 2, 3, and 4 by in accordance with
the punch hole position.
3. Set 3 sheets of paper in the tray of the PI, and
then feed them in the punch mode as samples.
4. Fold the sheets in half at the center and check the
[1]
misalignment of the punch holes.
5. Release the hook [1], and then remove the adjust-
ment cover [3] of the side guide plate /Rr [2].
15jff3c001na
6. For the tray /Lw, remove 2 screws [2] from the
side guide plate /Rr [1], and then slide the side
guide plate /Rr to the front and remove it.
[2]
15jff3c002na
4. MECHANICAL ADJUSTMENT
9