Table of Contents
Advertisement
4. MECHANICAL ADJUSTMENT
4.3
Height adjustment
A. Procedure
[1]
[2]
[2]
36
1. Close the DF.
2. Check to see if each of 2 stopper pieces [1] on the
DF side gets in touch with the dent [2] in the origi-
nal stopper plate /Lt on the main body side.
15saf3c003na
3. When each of the stopper pieces does not get in
[1]
touch with the dent in the original stopper plate /Lt
at the same time, make adjustments by turning
the adjusting screw A [1].
Note
• For the adjustment of the DF height, be sure
to make adjustments by turning the adjusting
screw A [1] as a rule. When a satisfactory
15saf3c004na
adjustment cannot be made with the adjust-
ing screw A [1], make adjustments turning the
adjusting screws A [1] and B [2] alternately.
Field Service Ver1.0 Jun.2005
Advertisement
Chapters
Table of Contents
