Table of Contents
Advertisement
4. MECHANICAL ADJUSTMENT
4.9
Stapler vertical position adjustment (FS-604)
Conduct this adjustment when there is a problem in clinching of the stapler.
Note
• Be sure not to move the stapler unit in the horizontal direction by hand. Otherwise, it may cause
the belt and gear tooth skipping.
A. Procedure
[1]
[2]
[3]
[1]
[3]
76
1
L=1mm
L=0.7mm
15sjf3c027na
[2]
[3]
15sjf3c028na
Field Service Ver2.0 Aug.2005
1. Perform the stapling operation and check to see if
there is one of the following clinching problems.
•
There is the bucking [1] of the staple.
•
The floating of the staple [2] is more than the
standard value (L = 1 mm).
•
The bending height [3] of the staple is more
than the standard value (L = 0.7 mm).
Conduct the following adjustment when one of
the conditions is met.
2. With the power source of the main body turned
ON, specify A4 and the 2-staple mode (flat sta-
pling), and then turn OFF the power source.
3. Open the front door, and then pull out the stacker
unit.
4. Remove 2 screws from the rail stopper, and then
pull out the stacker unit further. (See "4.1 Adjust-
ing the bypass gate.")
Note
• Be sure to place a support under the stacker
unit to prevent FS from falling down.
5. Remove the stapler unit cover. (See "2.3.1
Removing/reinstalling the stapler unit cover (FS-
604 only).")
6. Remove the cartridge.
7. Remove the flat-stapling stopper release units /Fr
and /Rr. (See "2.3.3 Replacing the stapler unit
(FS-604).")
8. Remove 4 screws [3] from each of the clincher /Fr
[1] and the clincher /Rr [2].
Advertisement
Chapters
Table of Contents
