Fns Adjusting The Tension Of The Upper Alignment Plate Drive Timing Belt (Fs-111); Fns Adjusting The Stapling Position (Flat Stapling) (Fs-111) - Konica Minolta 7155 Service Manual

[45] FNS Adjusting the Tension of the
4
Upper Alignment Plate Drive Timing
Belt (FS-111)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
Step
If the upper alignment plate drive belt
tensioner has been loosened as a result
1
of belt replacement or for some other
reason, adjust as described below.
b. Adjustment method (when some printed sheets
are skewed irregularly)
Step
Loosen the 2 set screws (see illustra-
1
tion).
Move the belt tensioner so that the end
is aligned with the center mark on the
scale, and retighten the screws.
Belt Tensioner
2
MODEL
7155/7165/7255/7272
Operation
Operation
Scale
Screws
7272fs1045
MANUAL REVISED EDITION
SERVICE MANUAL
[46] FNS Adjusting the Stapling Position
4
(Flat Stapling) (FS-111)
1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Check whether the virtual line running
between the stoppers is parallel to the
virtual line between the staplers.
This illustration is for FS-211. FS-111
has 4 flat-stapling stoppers.
1
Flat-Stapling Stoppers
If the lines are not parallel or if you need
to change the stapling position, carry out
2
adjustment as described below.
DATE
4 Dec. 2003
OTHER ADJUSTMENT
Operation
Staple Positions
7272fs1046
PAGE METHOD
1-149 ADDITION