Config: Misc; Config: Misc Idr-Esc-Type - Comtech EF Data CDM-625 Installation And Operation Manual

CDM-625 Advanced Satellite Modem
Front Panel Operation

5.4.10 CONFIG: Misc

Misc:
Audio-Vol
Select the parameter using the
5.4.10.1 CONFIG: Misc
Tx G.703/DDO Code= AMI
Rx G.703/IDI Code= AMI
Note: Parameters may only be edited if the Interface Type is G.703.
◄ ►
Use the the
using the
▲ ▼
Note: The choices displayed here depend on which G.703 interface type has been selected. The
choices are as follows:
•
•
•
•
5.4.10.2 CONFIG: Misc
IDR-ESC-Type Tx:64k Data
Note: Parameters may only be edited if the Framing Mode is IDR.
This menu permits a user to decide if the 64 kbps channel in the IDR Engineering Service
Channel (ESC) overhead (normally reserved for the two 32 kbps ADPCM audio channels) should
carry user-data instead. The rear panel Overhead connector provides the appropriate EIA-422
interface for this option.
Select the parameter to edit using the
keys, then press ENTER.
G.703-LineCode
HiRateESC
◄ ►
arrow keys, then press ENTER.
G.703 Ternary Code
arrow keys to select the parameter to edit. Select either appropriate G.703 code
arrow keys, then press ENTER.
HDB3 (for E1, E2 or sub-rate operation)
B8ZS ( for T1 and unbalanced T2 operation)
B6ZS (for balanced T2 operation)
AMI
IDR-ESC-Type
Rx:64k Data
◄ ►
MN-0000036 (Ref MN/CDM625.IOM)
IDR-ESC HSSI
WarmUp Stats (34)
(AMI,B8ZS)
(AMI,B8ZS) (34v)
(64kData,Audio)
arrow keys. Edit the parameter using the
5–33
Revision 1
RTS
(34v)
▲ ▼
arrow