Config: Edmac; Config: Misc - Comtech EF Data CDM-600 Installation And Operation Manual

CDM-600 Satellite Modem
Front Panel Operation
CONFIG: DROP & INSERT: INSERT CHANNEL TIMESLOTS
INS-CH: 1
Select the Time-slot to edit using the [←] [→] arrow keys and edit the value using the [↑]
[↓]arrow keys, then press ENTER.
The number of Channels and Time-slots shown depends on the data rate.
If the data rate is 1920 kbps, then only the E1 formats are available, and the CHAN/TS
menus are disabled. This is the 'fixed channel' mode where all timeslots are allocated in
order.
6.3.1.7

CONFIG: EDMAC

EDMAC MODE = MASTER (IDLE/MASTER/SLAVE)
Select either IDLE, MASTER, or SLAVE, using the [↑] [↓] arrow keys, then press
ENTER.
See Chapter 11 EDMAC for more information.
6.3.1.8

CONFIG: MISC

MISC:
ADPCM-AUDIO-VOL HI-RATE-ESC
Select the parameter to edit using the [←] [→] arrow keys, then press ENTER.
2 3
TS: 01 02 03
EDMAC ADDRESS = XXXX
An EDMAC MASTER is a unit which is local to the M&C computer, and
which passes messages, via the overhead, to a distant-end modem. The MASTER
address will always end in 0.
An EDMAC SLAVE is a unit, which is not local to the M&C computer, which
is at the distant-end of a satellite link. The SLAVE EDMAC address will
always end in 1.
G.703-LINE-CODE IDR-ESC-TYPE
4
04
WARM-UP
6–23
Revision 7
MN/CDM600.IOM