Programming The Alarm Feature - Nortel Modular ICS 6.0 Manual

182 / Using the Hospitality features

Programming the alarm feature

If you want to allow the room sets to program wake-up alarms,
there are a couple of program settings that need to be entered.
1. Place the appropriate programming overlay on the set you
are using to do programming.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
display shows Password:.
Û Ü ß Ý ß
3. Press
Terminals&Sets.
4. Press ' until the display shows Hospitality.
5. At the Hospitality heading, press ≠ until Alarm
displays.
6. Press ≠. Attn attempts:3 displays.
7. Press CHANGE until you find the number you want (1-5).
8. Press '. Retry intrvl:4 displays.
9. Press CHANGE until you find the number you want (2, 4, 6,
or 8).
10. Press '. Attn duration: 15 displays.
11. Press CHANGE until you find the number of seconds you
want (10, 15, 20, 30, 40, 50).
12. Press '. Time format:12 hr displays.
13. Press CHANGE to choose either 12hr or 24hr.
14. Press '. Expired alarms displays.
15. Press ≠. Notify set:None displays.
16. Press CHANGE to enter a set DN to be notified.
17. Press '. Use tone: N displays.
Modular ICS 6.0 System Coordinator Guide
(CONFIG). The
(ADMIN). The display shows
P0992640 03