Fujitsu PRIMEQUEST 2000 Series Message Reference page 167

MMB Messages
Please select a maintenance mode.
Meaning:
Select a maintenance mode.
Corrective action:
Select a maintenance mode.
Severity:
Info
W_00206
Maintenance of this unit cannot be performed because the unit does not satisfy requirements of any
of the maintenance modes.
Please check that the power status of partitions is Standby in the Partition Power Control Window,
and that there is available free units in the Partition Configuration Window.
Then please try again.
Meaning:
Maintenance work cannot be executed, as there is no selectable maintenance mode and the maintenance
criteria are not met.
Corrective action:
Check the power status of the partition in the [Partition Power Control]. If it is On, ask the system
administrator to power off the partition. Check in the [Partition Configuration] window, whether the status of
the unit is Free. If it is not Free, ask the system administrator to set it to Free. After confirmation, perform the
maintenance operation again.
Severity:
Warning
I_00207
The current Serial Number is the same as the previous Serial Number.
Are you sure?
Meaning:
During unit replacement maintenance of units with serial numbers, this message is displayed when the serial
number is the same for a unit before and after replacement and the [OK] button is clicked in the replacement
confirmation window.
Corrective action:
If there are no problems, the [OK] button is clicked and the subsequent window is displayed. If there is a
problem, confirm the target unit after clicking the [Cancel] button.
Severity:
Info
W_00207
The power status of the chassis is now Standby.
The selected Maintenance Operation Mode has become unavailable.
Check the system power status in the Power Supply Window.
Then please try again.
Meaning:
After Hot System Maintenance is selected and the [Next] button is clicked, if the power status of the system
(chassis) goes to Standby due to a user operation, 'Maintenance cannot be performed in the selected
maintenance mode, as the power status of the system (chassis) has been changed. Check the status of the
system (chassis) and try again' is notified.
Corrective action:
Check the power status of the system in the [Power Supply] window. If the status is Standby, ask the system
administrator to turn on the power of the system (chassis). After confirmation, perform the maintenance work
again.
Severity:
Warning
I_00208
Please select partition (s).
Meaning:
Displayed when partition is not specified and the [Next] button is clicked in the [Maintenance Wizard
(Maintenance Area)] window.
Corrective action:
C122-E178-02EN
151