NEC Xen IPK Features & Specifications Manual page 85

Xen IPK
Features and Specifications Manual
Use Memory Block 1-8-08 [Class 0f Service (Station) Feature
Selection 2] Page 2 LK6 to Allow (default: LED On) or Deny (LED Off)
a station to record, verify, or erase an Automated Attendant message.
Use Memory Block 1-8-01 to specify whether the PBR circuits in
the CPU(I) are used for Single Line Telephone or Automated
Attendant/DISA.
Use Memory Block 3-05 (Trunk Incoming Answer Mode Selection) to
assign Automated Attendant per CO/PBX line.
Use Memory Block 3-65 (Hold Tone Automated Attendant Selection)
to specify the message to be played to an extension or DID trunk on
an incoming call.
Use Memory Block 4-58 (Automated Attendant Selection for DID) to
specify the message for DID calls.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the
VRS(4)-U( ) ETU.
Restrictions
Tie/DID lines are not supported by the Automated Attendant feature.
CPU-based PBR circuits are required and used for this feature. The
CPUI-U( ) ETU of the Xen IPK system has four built-in PBR circuits
that are programmable for use with the Automated Attendant, DISA
feature, or Single Line Telephones. If all four circuits are programmed
for AA/DISA use, then a PBR( )-U( ) ETU must be installed for Single
Line Telephone use.
Automatic Trunk-to-Trunk Transfer and the Automated Attendant
features cannot be set for the same trunk at the same time.
General
If the VRS(4)-U( ) ETU or PBR is busy and there is an incoming CO/
PBX/DID call, the caller hears a ringback tone until a VRS channel and
PBR are available.
If Automated Attendant or PBR is busy, after the call is transferred to
the second level, a ringback tone is sent to the calling party.
DIT/ANA assigned to the same trunk has higher priority.
Automated Attendant and system Access Codes can be assigned
individually.
Automated Attendant assignment is assigned to tenants and follows
the tenants Day/Night/Weekend mode switching.
If Automated Attendant answer is assigned for a trunk and a
VRS(4)-U( ) ETU is not installed, second dial tone is provided for
incoming callers.
Features and Specifications Manual
A18 – 75