NEC Xen IPK Features & Specifications Manual page 234

July 2003
SERVICE
CONDITIONS
224 – C24
To transfer a call from a Multiline Terminal to its associated cordless
Single Line Telephone:
1. Single Line Telephone user goes off-hook (at this time, the call is
automatically connected to the Single Line Telephone).
2. Multiline Terminal user goes on-hook.
To use Hookflash:
Refer to operation for Single Line Telephone Access.
Data Assignment
Use Memory Block 4-39 (APR Ring Mode Assignment) to specify NON
(no ring), STA (ring Station Number only), or ALL (ring all stations) for
SLTs connected to the APR/PA Adapter for the cordless telephone.
Default is STA.
Use Memory Block 4-59 (APR Hookflash selection) to allow or deny
Hookflash on an APR/PA Adapter.
Restrictions
A voice announced internal call to the Multiline Terminal does not ring
the cordless telephone.
Only one cordless Single Line Telephone can be connected to an
APR/PA Adapter.
When CO Prime Line is assigned to the associated Multiline Terminal,
internal dial tone cannot be transferred to the cordless telephone.
The cordless telephone requires a PBR circuit while dialling. When all
PBR circuits are busy, a busy tone is heard when the phone goes
off hook.
General
This feature works with analogue cordless Single Line Telephones.
System Programming determines whether the cordless telephone
rings when any call is directed to the associated Multiline Terminal,
rings only for Tie/DID, DIT/ANA, and internal calls, or does not ring.
The following are not supported for cordless telephones: disconnect
signal, DTMF sending (to cordless telephone), Message Wait, and
DP-type cordless telephones.
A maximum of 120 APR/APA Adapters can be installed in Multiline
Terminals on the Xen IPK Expanded system, or a maximum of 32 on
the Xen IPK Basic system.
The Multiline Terminal user and its associated cordless telephone user
cannot talk to each other.
NEC Business Solutions Ltd
Cordless Telephone Connection