NEC Xen IPK Features & Specifications Manual page 423

Xen IPK
SERVICE
CONDITIONS
Features and Specifications Manual
To start a conference call from an incoming CO call using an
Automated Attendant:
1. Call a trunk that is set as Automated Attendant.
2. Select the option for an extension connected to the Conference
Bridge.
3. When the voice prompt is heard, enter the Conference Bridge 1 or 2
password and press
4. Start the conference call.
To start a conference call from an incoming CO call using an
Attendant:
1. Call the Attendant and ask to be transferred to an extension
connected to the Conference Bridge.
2. When the voice prompt is heard, enter the Conference Bridge 1 or 2
password and press
3. Start the conference call.
Data Assignment
The CNF(8)-U( ) ETU must be assigned as an SLI(8)-U( ) ETU using
Memory Block 7-1.
The ports connected to the CNF(8)-U( ) ETU must be assigned as
voice mail ports using Memory Block 4-35 to ensure proper disconnect
signals.
All ports that are set to the same conference group should be set to
the same Master Hunt Group using Memory Blocks 4-14 and 4-15.
When CNF is set for two, four-party conferences, ports 1~4 should be
set to the same Master Hunt Group, and ports 5~8 should be set to a
different Master Hunt Group using Memory Blocks 4-14 and 4-15. This
allows two different Pilot Numbers for each conference.
- OR -
If only one Pilot Number is needed, out all eight ports in one hunt
group using Memory Block 4-15. When the password is entered, the
conference selected is the conference you enter.
DIT assignment may be set to Master Hunt Group using Memory
Block 3-42 for Day or 3-43 for night.
Features and Specifications Manual
L
.
L
.
M3 – 413