Pooled Line (Outgoing) - NEC Xen IPK Features & Specifications Manual

Pooled Line (Outgoing)

FEATURE
DESCRIPTION
SYSTEM
AVAILABILITY
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Features and Specifications Manual
The Pooled Line feature allows Multiline Terminal users to seize an outside
line on one Pooled line key. One Pooled line key can accommodate a Trunk
group or Route Advance Block.
Terminal Type
All Multiline Terminals.
Required Components
None.
To originate an outside call:
1. Press the Pooled line key, and receive outside line dial tone.
2. Dial the desired telephone number.
Data Assignment
A Pooled Line (Outgoing) can be programmed to appear at a station
using line key assignment in System Programming.
Restrictions
A Pooled Line (Outgoing) cannot receive incoming calls.
General
A maximum of 48 pooled groups are allowed per system. Each pooled
group corresponds to a Trunk Group number (1~32) or a Route
Advance Block number (1~32).
Pooled Line LED indicates the status of the pooled group as follows:
On: All trunks belonging to the pooled group are in use.
Off: Some or all trunks belonging to the pooled group are idle.
When an idle Pooled line key is pressed, an idle trunk belonging to
that pooled group is automatically selected. If the Xen IPK system is
designated as KF registration, this feature is not available.
A user on a Pooled Line can access Call Park - System, Call Transfer,
and Conference.
Trunk Queuing can be set when the Pooled line key is in a busy status
(red LED).
When a trunk is selected from Pooled line key, it appears on a CO line
key or on a Call Appearance key (CAP) on the Multiline Terminal.
P-3
P3 – 455