Configuration Information; Configuration Tasks For Is-Is - Dell S4048–ON Configuration Manual

By default, Dell Networking OS supports dynamic host name exchange to assist with troubleshooting and configuration. By assigning
a name to an IS-IS NET address, you can track IS-IS information on that address easier. Dell Networking OS does not support ISO
CLNS routing; however, the ISO NET format is supported for addressing.
To support IPv6, the Dell Networking implementation of IS-IS performs the following tasks:
• Advertises IPv6 information in the PDUs.
• Processes IPv6 information received in the PDUs.
• Computes routes to IPv6 destinations.
• Downloads IPv6 routes to the RTM for installing in the FIB.
• Accepts external IPv6 information and advertises this information in the PDUs.
The following table lists the default IS-IS values.
Table 45. IS-IS Default Values
IS-IS Parameter
Complete sequence number PDU (CSNP) interval
IS-to-IS hello PDU interval
IS-IS interface metric
Metric style
Designated Router priority
Circuit Type
IS Type
Equal Cost Multi Paths

Configuration Information

To use IS-IS, you must configure and enable IS-IS in two or three modes: CONFIGURATION ROUTER ISIS, CONFIGURATION
INTERFACE, and ( when configuring for IPv6) ADDRESS-FAMILY mode. Commands in ROUTER ISIS mode configure IS-IS globally,
while commands executed in INTERFACE mode enable and configure IS-IS features on that interface only. Commands in the
ADDRESS-FAMILY mode are specific to IPv6.
NOTE: When using the IS-IS routing protocol to exchange IPv6 routing information and to determine destination
reachability, you can route IPv6 along with IPv4 while using a single intra-domain routing protocol. The configuration
commands allow you to enable and disable IPv6 routing and to configure or remove IPv6 prefixes on links.
Except where identified, the commands described in this chapter apply to both IPv4 and IPv6 versions of IS-IS.

Configuration Tasks for IS-IS

The following describes the configuration tasks for IS-IS.
• Enabling IS-IS
• Configure Multi-Topology IS-IS (MT IS-IS)
• Configuring IS-IS Graceful Restart
• Changing LSP Attributes
• Configuring the IS-IS Metric Style
• Configuring IS-IS Cost
• Changing the IS-Type
• Controlling Routing Updates
• Configuring Authentication Passwords
Default Value
10 seconds
10 seconds
10
Narrow
64
Level 1 and Level 2
Level 1 and Level 2
16
Intermediate System to Intermediate System
449