During Maintenance Or Inspection; When Handling Supplies - Toshiba e-studio 2000ac Safety Information Manual

Other points
 Be very careful to treat the touch panel gently and never hit it. Breaking the surface could cause
malfunctions.
 Do not turn the power OFF with misfed paper remaining inside the equipment.
This could cause a malfunction when the power is turned ON next time.
 Be sure to turn the power OFF when leaving the office or if there is a power outage. However, do not
turn the power OFF if the weekly timer is in use.
 Be careful because the paper exit area and paper just after exiting are hot.
 Do not place anything other than paper on the receiving tray. This could disturb a normal operation
and cause malfunctions.
 Do not touch the photoconductive drum, transfer belt and 2nd transfer roller. This could cause
image problems.
 Do not open/close the covers and the bypass tray, or pull out the drawers during printing.
 During maintenance or inspection
 Never attempt to repair, disassemble or modify the Multifunctional Digital Systems by yourself. You
could cause a fire or get an electric shock.
Always contact your Service representative for maintenance or repair of the internal parts of the
Multifunctional Digital Systems.
 Do not let liquids such as water and oil get into the system when cleaning the floor. This could cause
a fire and give you an electric shock.
 Always keep the plug and outlet clean. Prevent them from accumulating dust and dirt. This could
cause a fire and give you an electric shock due to the heat released by electric leakage.
 Do not touch the stapling area. The actual needle point could cause you personal injury.
Other points
 Do not use such solvents as thinner or alcohol when cleaning the surface of the Multifunctional
Digital Systems.
- This could warp the shape of the surface or leave it discolored.
- When using a chemical cleaning pad to clean it, pay attention to any cautionary points.
 Repair parts will be provided for a period of 7 years after the final manufacturing of the product.
 The life of each consumable differs depending not only on the copy/print volume but also on other
factors (operating time, output image, media type and so on). Due to this, the life cannot be
specified in a simple description using the copy/print volume. For more details, contact your
supplier where you purchased the product.
 When handling supplies
 Never attempt to incinerate toner cartridges and waste toner boxes. Dispose of used toner
cartridges and waste toner boxes in accordance with local regulations.
Other points
 Read the operator's manual carefully to replace the toner cartridge using the correct procedure. An
improper procedure could cause toner leakage or scattering.
Safety Information 21