Quick Setup - IBM Infoprint 6700 Series User Manual

QUICK SETUP

QUICK SETUP
Print Intensity
Print Speed
Print Mode
Media Handling
Tear-Off Strip*
Paper Feed Shift
Label Length
Label Width
Ver Image Shift
Hor Image Shift
Orientation
6
Gap/Mark Sensor
Auto Calibrate
7
Validator Funct.
Active IGP Emul
Continued at the top of next page
Notes:
* = Factory Default
1
Maximum value depends on the printer model width (4, 6, or 8 inches) and printhead (203 or 300 dpi).
2
You can change the unit value from inches to millimeters under Units (in MEDIA CONTROL) when Admin User
is enabled.
3
Based on the current value setting for the Label Length (in QUICK SETUP), up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the printer model (see Appendix A, "Specifications").
5
Maximum value depends on model width and size of DRAM installed (see Appendix A, "Specifications").
6
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 144. If you change
the Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
7
Appears only if a validator is installed.
-3* -15 to 15
1
6 ips* 1-10 ips
Transfer* Direct
Tear-Off
2
0.00 inches* -0.50 to X inches
2, 4
4 or 6 inches* 00.1 to 99.0 inches
2, 4
4.1, 6.6, or 8.5 inches*
2
0.00 inches* -1.00 to X inches
2
0.00 inches* -1.00 to 1.00 inches
Portrait* Landscape
Disable* Mark
Run Calibrate
Enable* Disable
IGP/PGL* PPI/IGL
Loading A Saved Configuration
Peel-Off Cut
3
5
4
00.1 to 8.5 inches
3
Inv. Portrait Inv. Landscape
Gap Advanced Gap
PPI/TGL PPI/IGL
QUICK SETUP
Continuous
Advanced Notch
PPI/STGL IGP/VGL
113