Lacp Port-Priority - Cisco WLC 5700 Series Command Reference Manual

Layer 2/3, cisco ios xe release 3e
Hide thumbs Also See for WLC 5700 Series:
Table of Contents

Advertisement

lacp port-priority

lacp port-priority

To configure the port priority for the Link Aggregation Control Protocol (LACP), use the lacp port-priority
command in interface configuration mode. To return to the default setting, use the no form of this command.
lacp port-priority priority
no lacp port-priority
Syntax Description
priority
Command Default
The default is 32768.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
The lacp port-priority interface configuration command determines which ports are bundled and which ports
are put in hot-standby mode when there are more than eight ports in an LACP channel group.
An LACP channel group can have up to 16 Ethernet ports of the same type. Up to eight ports can be active,
and up to eight ports can be in standby mode.
In port-priority comparisons, a numerically lower value has a higher priority: When there are more than eight
ports in an LACP channel group, the eight ports with the numerically lowest values (highest priority values)
for LACP port priority are bundled into the channel group, and the lower-priority ports are put in hot-standby
mode. If two or more ports have the same LACP port priority (for example, they are configured with the
default setting of 65535), then an internal value for the port number determines the priority.
Note
The LACP port priorities are only effective if the ports are on the controller that controls the LACP link.
See the lacp system-priority global configuration command for determining which controller controls
the link.
Use the show lacp internal privileged EXEC command to display LACP port priorities and internal port
number values.
For information about configuring LACP on physical ports, see the configuration guide for this release.
Layer 2/3 Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
30
Port priority for LACP. The range is 1 to 65535.
Layer 2/3 Commands
Modification
This command was introduced.
OL-32323-01

Advertisement

Table of Contents
loading

Table of Contents