Removing A 2.5-Inch Simple-Swap Hard Disk Drive Or Solid-State Drive; Installing An Adapter - IBM 6380 User Manual

To remove a 2.5-inch hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Rotate the drive tray handle to the open position.
3. Grasp the handle; then, pull the drive out of the drive bay.
4. Store the drive for later use.

Removing a 2.5-inch simple-swap hard disk drive or solid-state drive

Note: The following illustration shows how to remove a 2.5-inch simple-swap hard
disk drive or solid-state drive from a 2U chassis.
To remove a 2.5-inch simple-swap hard disk drive or solid-state drive, complete the
following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the system-board tray and all attached devices (see "Turning off the
3. Remove the filler panel from the bay that contains the simple-swap hard disk
4. Slide the retention tab; then, pull the drive out of the drive bay.
5. Store the drive for later use.

Installing an adapter

The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
32
System x iDataPlex dx360 M2: User's Guide
on page 23.
Note: A hard disk drive or filler panel must always be installed in each drive
bay when the server is turned on.
Note: If you install or remove a hard disk drive, see the documentation that
comes with your RAID adapter for information about reconfiguring the disk
arrays.
on page 23.
system-board tray" on page 21).
drive.
Note: A drive or filler panel must always be installed in each drive bay when
the server is turned on. In each drive bay that contains a simple-swap hard disk
drive or solid-state drive, a filler panel must always be installed in addition to the
drive.