Ndis 4.0 (Windows Nt) Driver Messages - IBM xSeries 300 Hardware Maintenance Manual

Table 3. NetWare driver messages for the Ethernet controller (continued)
Message
Failed to create AFT group.
Make sure that the drivers
for supported adapters are
loaded, primary adapter is
bound to protocols, and
secondary adapter is not
bound to any protocols.
Error identifying slot
numbers for the specified
board names.
Can't unbind specified slot
from AFT group. Make sure
that the slot you specified is
for the primary adapter in an
AFT group.
LAN adapter at slot nnnn
(Port 0xaa) failed to reset.
Check the state of the
adapter.
AFT is not supported on this
version of NetWare
Failed to allocate resources
tags.
Please unload all LAN
drivers before unloading
AFT.NLM.

NDIS 4.0 (Windows NT) driver messages

This section contains the error messages for the NDIS 4.0 drivers. The explanation
and recommended action are included with each message.
Table 4. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller
Error code
(hex)
0x00
0x01
0x02
Description
Explanation: Binding of protocol failed. Protocol is either
not bound to any adapter or is bound to more than one
adapter in the group. Action: Ensure that the protocol is
bound to only adapter in an AFT team.
Explanation: The mapping between the board name entered
and the slot number for an adapter could not be
established. Action: Check the board name for the adapter
before issuing the bind command.
Explanation: The number entered in the unbind command
was not the primary adapter in an AFT group. Action:
Reissue the unbind command and specify the slot number
for the primary adapter.
Explanation: The adapter that you specified could not be
initialized. Action:
1. Load the driver for the supported adapter.
2. Check that the adapter is seated properly in the slot and
try loading the AFT module again.
Explanation: The NetWare on your server is not a version
™
. supported by AFT. Action: Load and bind AFT only on
supported versions of NetWare (currently version 4.11 and
above).
Explanation: An unknown error has occurred when trying
to allocate needed resources for the AFT module. Action:
Check server configuration.
Explanation: An attempt was made to unload the AFT.NLM
module before unloading the adapter driver. Action:
Unload the adapter driver before unloading the AFT
module.
Description
Explanation: The driver could not register the specified interrupt. Action:
Using the Configuration/Setup Utility program, make sure that a PCI
interrupt is assigned to your Ethernet card, and that Ethernet is enabled.
Explanation: One of the PCI cards did not get the required resources.
Action: Using the Configuration/Setup Utility program, make sure that a
PCI interrupt is assigned to your Ethernet card, and that Ethernet is
enabled.
Explanation: Bad node address (multicast address). Action: Make sure the
locally administered address is valid, if one is specified. The address can
not be a multicast address.
25
Chapter 3. Diagnostics