Diagnostic Error Codes - IBM eserver xSeries 440 8687 Hardware Maintenance Manual

Service Processor message
System shutoff due to CPU x over
temperature
System shutoff due to DASD x temperature
System shutoff due to high ambient
temperature
Uncorrectable Cache Error Detected.
Removed Failed Component(s) from active
configuration.
Uncorrectable memory error on bank Jxx
VRM x Power Good Fault
The service processor also generates a large number of information, error and
warning messages.
If an RXE-100 unit is attached, the service processor may generate further
messages specific to this unit. These are listed in the following table and are
intended to be self-explanatory.

Diagnostic error codes

Note: In the following error codes, if xxx is 000, 195, or 197, do not replace a
Error code/symptom
001-198-000 (Test Aborted)
001-250-000 (Test aborted)
001-250-001 (Failed SMP Expansion Board
ECC)
001-250-002 (Failed SMP Expansion Board
ECC)
001-250-099 (Failed SMP Expansion Board
ECC)
162
xSeries 440 Type 8687: Hardware Maintenance Manual
FRU/action
1. Heat sink
2. Fans
1. SCSI drives
2. Fans
3. SCSI backplane
1. Check room temperature.
2. Fans.
3. Light Path assembly.
v Run diagnostics.
v Run memory diagnostics.
v VRM
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to abort the test.
197 This is a warning error and may not indicate a hardware failure.
For all error codes, replace/follow the FRU/Action indicated.
FRU/action
1. Check error log for messages.
2. Run Quick Memory Test All Banks.
3. Reload system BIOS and rerun test.
1. Check error log for messages (see "Error logs" on page 54).
2. SMP board
1. Check error log for messages (see "Error logs" on page 54).
2. SMP board 1 (bottom).
1. Check error log for messages (see "Error logs" on page 54).
2. SMP board 2 (top).
1. Check error log for messages (see "Error logs" on page 54).
2. SMP board 1 (bottom) and 2 (top).