General Panel - Cisco ROUTER-SDM-CD User Manual

Edit Dynamic Multipoint VPN (DMVPN)
Delete

General Panel

IP Address
Mask
Tunnel Source
Tunnel Destination
IPSec Profile
Cisco Router and Security Device Manager 2.5 User's Guide
15-14
Click to delete a DMVPN tunnel configuration.
In this panel add or edit general configuration parameters of the DMVPN tunnel.
Enter the IP address of the tunnel. This must be a private address and must be in
the same subnet as the other tunnel addresses in the DMVPN. If you are
configuring a spoke, you must use the address that the hub administrator has
assigned to your router so that no address conflicts occur.
Enter the subnet mask that the hub administrator has assigned to the DMVPN. For
more information, see
Select the interface that the tunnel is to use, or enter that interface's IP address.
See Using Interfaces with Dialup Configurations
configured for a dialup connection.
Click This is a multipoint GRE tunnel if this is a DMVPN tunnel in a
fully-meshed network. Click IP/Hostname and specify an IP address or hostname
if this is a hub-and-spoke network
Select a configured IPSec profile for this tunnel. The IPSec profile defines the
transform sets that are used to encrypt traffic on this tunnel.
IP Addresses and Subnet
Chapter 15
Masks.
before you select an interface
DMVPN
OL-4015-12