Cisco ROUTER-SDM-CD User Manual page 848

Reset to Factory Defaults
Understanding How to Give the PC a Dynamic or Static IP Address After You Reset
Note
Cisco Router and Security Device Manager 2.5 User's Guide
39-4
restricting it to the LAN interface, and only from the internal subnet defined on
that interface. After you access the router, you can change the router default IP
address and set it to allow remote access.
If you want to use Cisco SDM after you reset, you have to give your PC a static
or dynamic IP address, depending on the type of router that you have. Use the
following table to determine the type of address to give the PC.
Routers Needing Dynamic Addresses
SB10x
Cisco 83x, 85x, and 87x
Cisco 1701, 1710, and 171x
Cisco 180x and 181x
The process for giving the PC a static or dynamic IP address varies slightly
depending on the version of Microsoft Windows the PC is running.
Do not reconfigure the PC until after you reset the router.
Microsoft Windows NT
From the Control Panel, double-click the Network icon to display the Network
window. Click Protocols, select the first TCP/IP Protocol entry, and click
Properties. In the Properties window, select the Ethernet adapter used for this
connection. Click Obtain an IP Address Automatically to obtain a dynamic IP
address. For a static IP address, click Specify an IP address. Enter the IP address
10.10.10.2 or any other address in the 10.10.10.0 subnet greater than 10.10.10.1.
Enter the subnet 255.255.255.248. Click OK.
Microsoft Windows 98 and Microsoft Windows ME
From the Control Panel, double-click the Network icon to display the Network
window. Double-click the TCP/IP Protocol entry with the Ethernet adapter being
used for this connection to display TCP/IP Properties. In the IP address tab, click
Obtain an IP Address Automatically to obtain a dynamic IP address. For a static
Chapter 39 Configuration Management
Routers Needing Static Addresses
Cisco 1721, 1751, and 1760
Cisco 1841
Cisco 2600XM, and 2691
Cisco 28xx, 36xx, 37xx, and 38xx
OL-4015-12