802.1X Authentication On Layer 3 Interfaces - Cisco ROUTER-SDM-CD User Manual

Chapter 4 802.1x Authentication
Delete

802.1x Authentication on Layer 3 Interfaces

Note
Prerequisite Tasks
Enable 802.1x Authentication Globally
Interfaces Table
OL-4015-12
Click Delete to remove a chosen client from the exception list.
This window allows you to configure 802.1x authentication on a
Interface. It lists Ethernet ports and VLAN interfaces that have or can be
configured with 802.1x authentication, allows you to choose a Virtual Template
interface for untrusted clients, and create an exception list for clients to bypass
802.1x authentication.
If policies have been set using the CLI, they will appear as read-only information
in this window. In this case, only enabling or disabling 802.1x is allowed in this
window.
If a prerequisite task appears in the window, it must be completed before 802.1x
authentication can be configured. A message explaining the prerequisite task is
displayed, along with a link to the window where the task can be completed.
Check Enable 802.1x Authentication Globally to enable 802.1x authentication
on all Ethernet ports.
The Interfaces table has the following columns:
Interface—Displays the name of the Ethernet or VLAN interface.
802.1x Authentication—Indicates whether 802.1x authentication is enabled for
the Ethernet port.
Cisco Router and Security Device Manager 2.5 User's Guide
802.1x Authentication on Layer 3 Interfaces
Layer 3
4-9