Irb For Ethernet; Layer 3 Ethernet Configuration - Cisco ROUTER-SDM-CD User Manual

Chapter 3 LAN Wizard
Element
DHCP Server
Configuration
Start IP
End IP

IRB for Ethernet

Layer 3 Ethernet Configuration

OL-4015-12
Field Reference
Table 3-10 DHCP Pool for BVI
Description
If you want to have the router function as a DHCP server, check DHCP
Server Configuration.
Enter the starting IP address for the pool. Be sure to specify IP addresses in
the same subnet as the IP address you gave the interface. For example, If
you gave the interface an IP address of 10.10.22.1, with a subnet mask of
255.255.255.0, you have over 250 addresses available for the pool, and you
might specify a start IP Address of 10.10.22.2.
Enter the ending IP address for the pool. Using the above example, the end
IP address would be 10.10.22.254.
If your router has a wireless interface, you can use Integrated Routing and
Bridging to have this interface form part of a bridge to the wireless LAN, and
enable traffic destined for the wireless network to be routed through this interface.
Click Yes if you want to configure this Layer 3 interface for Integrated Routing
and Bridging.
If you do not want this interface to be used in bridge to the wireless interface, click
No. You will still be able to configure it as a regular routing interface.
Cisco SDM supports Layer 3 Ethernet configuration on routers with installed
3750 switch modules. You can create VLAN configurations and designate router
Ethernet interfaces as DHCP servers.
Cisco Router and Security Device Manager 2.5 User's Guide
IRB for Ethernet
3-9