Cisco ROUTER-SDM-CD User Manual page 332

Administering Easy VPN Remote Connections
Table 12-15 Identical Addressing Tab Fields (continued)
Element
Add
Enable split tunneling
Accessible Devices
Device Local IP
Device Global IP
Add
Edit
Delete
Warning Messages
Cisco Router and Security Device Manager 2.5 User's Guide
12-38
Description
Clicking Add displays the dialog that enables you to configure a
loopback interface.
Split tunneling enables the router to only use the VPN tunnel to send
traffic to network addresses given to it by the Easy VPN server and
to send other traffic through the Internet. To enable the router to use
this feature, click Enable split tunneling.
The local IP address of a device that is identified as a device that
must be reached by other networks.
The global IP address given to a device that is identified as a device
that must be reached by other networks. Because the global IP
address for each device must be routable from the Easy VPN server,
you must obtain these addresses from the Easy VPN server
administrator. Each IP address must be on the same subnet, and one
address must be reserved for use by non accessible devices on the
local network.
To add the local IP address and global IP address of a device, click
Add.
To change the IP address information for a device, choose an entry
and click Edit.
To remove an entry for an accessible device, choose the entry and
click Delete.
Cisco SDM displays a warning message when you click OK if it detects any of
the following problems:
• There are no devices added.
If you enter an IP address for the non accessible devices that is already used
•
by a router interface.
If you enter an IP address for the non accessible devices that is already used
•
as a global IP address for an accessible device.
Chapter 12 Easy VPN Remote
OL-4015-12