Connection: Analog Modem - Cisco ROUTER-SDM-CD User Manual

Chapter 6 Edit Interface/Connection

Connection: Analog Modem

Encapsulation
Remote Phone Number
Options
Clear Line
IP Address
OL-4015-12
Complete these fields if you are configuring an analog modem connection.
Because Cisco SDM supports only PPP encapsulation over an analog modem
connection, the encapsulation shown is not editable.
PPP chosen.
Enter the phone number of the destination of the analog modem connection.
Click if you need to associate ACLs with a dialer list to identify interesting traffic
or enter timer settings.
Identifying interesting traffic will cause the router to dial out and create an active
connection only when the router detects interesting traffic.
Timer settings will cause the router to automatically disconnect a call after the
line is idle for the specified amount of time.
Click to clear the line. You should clear the line after creating an async connection
so that interesting traffic triggers the connection.
Choose Static IP address, IP Unnumbered, or IP Negotiated. If you choose
Specify an IP address, complete the fields below.
IP Address
Enter the IP address for this point-to-point subinterface. Obtain this value from
your network administrator or service provider. For more information, see
Addresses and Subnet
Cisco Router and Security Device Manager 2.5 User's Guide
Masks.
Connection: Analog Modem
IP
6-51