Cisco ROUTER-SDM-CD User Manual page 609

Chapter 26 Network Address Translation
Translate from Interface
Note
Access Rule
Translate to Interface
OL-4015-12
This area shows the interfaces from which packets needing address translation
come in to the router. It provides fields for specifying the IP address of a single
host, or a network address and subnet mask that represent the hosts on a network.
Outside Interfaces
If you chose From outside to inside, this area contains the designated outside
interfaces.
If this area contains no interface names, close the Add Address Translation Rule
window, click Designate NAT interfaces in the NAT window, and designate the
router interfaces as inside or outside. Then return to this window and configure
the NAT rule.
Dynamic NAT translation rules use access rules to specify the addresses that need
translation. If you choose From outside to inside, these are the
addresses. Enter the name or number of the access rule that defines the addresses
you want to translate. If you do not know the name or number, you can click the
... button and choose an existing access rule, or you can create a new access rule
to use.
This area shows the interfaces from which packets with translated addresses exit
the router. It also provides fields for specifying the translated address.
Inside Interface(s)
If you choose From outside to inside, this area contains the designated inside
interfaces.
Cisco Router and Security Device Manager 2.5 User's Guide
Network Address Translation Rules
outside global
26-27