Dmz Service Configuration - Cisco ROUTER-SDM-CD User Manual

Chapter 8 Create Firewall
To configure a DMZ service entry:
To edit a DMZ service entry:

DMZ Service Configuration

Host IP Address
OL-4015-12
Service Type
The type of service, either Transmission Control Protocol (TCP) or User
Datagram Protocol (UDP).
Service
The name of the service, such as Telnet, or FTP, or a protocol number.
Click Add, and create the entry in the DMZ Service Configuration window.
Select the service entry, and click Edit. Then, edit the entry in the DMZ Service
Configuration window.
Create or edit a DMZ service entry in this window.
Enter the address range that will specify the hosts in the DMZ that this entry
applies to. The firewall will allow traffic for the specified TCP or UDP service to
reach these hosts.
Start IP Address
Enter the first IP address in the range; for example, 172.20.1.1. If Network
Address Translation (NAT) is enabled, you must enter the NAT-translated address,
known as the inside global
End IP Address
Enter the last IP address in the range; for example, 172.20.1.254. If NAT is
enabled, you must enter the NAT-translated address.
Cisco Router and Security Device Manager 2.5 User's Guide
Advanced Firewall Configuration Wizard
address.
8-7