Configuring Non-Registered Device Settings - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual

4 Select one or both of the following options:
Allow Preboot Services to overwrite existing files when uploading: Select this option only
if you want existing image files to be overwritten during imaging.
Only allow uploads to the following directories: This option allows you to determine where
images can be restored on the imaging server.
Specify a full path to the directory in the Add field, then click Add to enter it into the list box.
These are the directories where images are allowed to be saved on the imaging server. These
are the locations that can be selected when configuring where to store image files.
Use Move up or Move down to rearrange the order of the locations, including the order of the
imaging servers that are listed.
To remove a directory path from the listing, select the path and click Remove. You can select
multiple paths for removing.
5 Click either Apply or OK to save the changes.
This sets the default image storage settings for the ZENworks Management Zone.

29.4.3 Configuring Non-registered Device Settings

The following configurations can be set after a device is imaged. The settings are applied to devices
not registered in the ZENworks Management Zone.
For more information, see
To configure default ID settings for non-registered devices:
1 In the ZENworks Control Center, click the Configuration tab, which displays the following
Management Zone Settings section:
2 In this section, click Preboot Services to display the configuration sections.
3 Locate the Non-Registered Device Settings section:
374 Novell ZENworks 7.2 Linux Management Administration Guide
Section 28.3.4, "Non-registered Device Settings," on page 326.