Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual page 612

Understanding the novell-zmgprebootpolicy Components
To initiate the novell-zmgprebootpolicy daemon, enter the following command (listed under Script
Location) on the Linux command line in a terminal program:
/etc/init.d/novell-zmgprebootpolicy
Table D-11
uses:
Table D-11
Script Arguments:
Executable:
Configuration File:
Configuring novell-zmgprebootpolicy
The novell-zmgprebootpolicy configuration file (novell-zmgprebootpolicy.conf),
contains the following parameters:
Table D-12
Parameter
LocalInterface =
10.0.0.1
612 Novell ZENworks 7.2 Linux Management Administration Guide
lists the arguments for this command, the executable it starts, and the configuration file it
Novell-zmgprebootpolicy Command Details
start, stop, restart, force-reload, status, showpid (for descriptions of these
arguments, see
/opt/novell/zenworks/preboot/bin/novell-zmgprebootpolicyd
/etc/opt/novell/zenworks/preboot/novell-
zmgprebootpolicy.conf
Novell-zmgprebootpolicy Parameters
Description
The IP address that is used by the Policy server.
This setting is intended only for use on servers with multiple LAN interfaces.
The address must be valid on the server.
By default, this parameter is commented out.
"Understanding Script Arguments" on page 613)