Make To Proxy (Img Makep) - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual

Parameter
[comp=comp level]
xpartition
Examples
makel Examples
Table E-2
Example
img makel8 /imgs/dellnt.zmg
img makel /imgs/dellnt.zmg
img makel /imgs/dellnt.zmg x2 x3 Takes an image of all partitions except those in slots 2 and
E.3.2 Make to Proxy (img makep)
Using the bash prompt, the following example explains the syntax and available parameters that you
can use with the makep "make to proxy" parameter:
img makep address filepath [comp=comp level] [xpartition]
Commands
makep Commands
Table E-3
Parameter
address
620 Novell ZENworks 7.2 Linux Management Administration Guide
Specifies
comp level is the amount of compression used when creating the image. Specify
any number from 0-9. 0 means no compression. 1 is the same as Optimize for
Speed and is used by default if you do not specify this parameter. 6 is the same as
Balanced. 9 is the same as Optimize for Space.
The partition number (as displayed by img dump) of a local partition to exclude
from the image. You can repeat this parameter as needed to exclude multiple
partitions.
If you omit this parameter, all partitions are included in the image except the one
where the image is stored.
Explanation
Takes an image of all partitions except the one in slot 8 and
saves the image to imgs/dellnt.zmg in the partition in
slot 8. (Assumes that slot 8 contains a primary partition.)
Takes an image of all partitions and saves it to imgs/
dellnt.zmg in the ZENworks partition. (Assumes that the
partitions have been installed.)
3 and saves the image to imgs/dellnt.zmg in the
ZENworks partition. (Assumes that the partitions have
been installed.)
Specifies
The IP address or DNS name of the imaging server to store the image on.