Table of Contents
Advertisement
Multicast images. You can apply an image of one device to many other devices. This is an
excellent feature for initially setting up a lab.
Configure Dell devices. You can configure basic boot settings on Dell devices.
27.3 Preboot Bundles
In the ZENworks Control Center, Preboot Services tasks are contained in Preboot bundles. The
following five Preboot bundle types are available:
AutoYaST bundle: Describes the location and access protocol of an AutoYaST response file
and network installation directory for SUSE
Services to launch an AutoYaST automated installation of SUSE Linux. This is only available
for Linux devices that are PXE-enabled. AutoYaST bundles cannot be run using a boot CD or a
ZENworks partition.
Dell Configuration bundle: Describes the location of files and scripts for configuring Dell
servers. This bundle allows you to use Preboot Services to configure the server's BIOS, BMC,
RAID, and DRAC settings and to create a Dell utility partition. This is only available for Linux
devices that are PXE-enabled. Dell Configuration bundles cannot be run using a boot CD or a
ZENworks partition.
Kickstart bundle: Describes the location and access protocol for a kickstart response file. This
bundle allows you to use Preboot Services to launch an automated kickstart installation of Red
Hat Linux. This is only available for Linux devices that are PXE-enabled. Kickstart bundles
cannot be run using a boot CD or a ZENworks partition.
ZENworks Image bundle: Lists one or more ZENworks images (base plus add-ons) that can
be restored on a device. This bundle allows you to define simple imaging operations.
ZENworks Multicast bundle: Specifies an image that can be sent using the multicast
protocol. This bundle allows you to send an image to a large number of devices in a single
operation, thus minimizing network traffic. It is ideal for labs, classrooms, and staging areas.
ZENworks Script bundle: Allows you to write a custom Linux bash script. This provides
detailed control over ZENworks imaging operations, as well as most Linux-based preboot
tasks.
To create one of these bundles: In the ZENworks Control Center interface, click Bundles > New >
Bundle > Preboot bundle > Next, then select a bundle type. For more information, see
"Using Preboot Services," on page
27.4 Configuring Preboot Services
In the ZENworks Control Center, you can set up default Preboot Services configurations for all of
your devices. Some settings can be overridden at the device, group, or folder level.
You can configure the following settings per
Preboot Services Menu options: The menu contains seven options: 1) Start ZENworks
imaging, which automatically executes the bundle; 2) Start ZENworks imaging maintenance,
which accesses the bash prompt; 3) Disable ZENworks partition; 4) Enable ZENworks
partition; 5) Start DELL DTK; 6) Start DELL DTK (Maintenance Mode); and, 7) Exit, which
resumes booting. You can configure whether the Preboot Services Menu is displayed upon
booting, not displayed, or allowed to be displayed only when Ctrl+Alt is pressed during
booting.
318 Novell ZENworks 7.2 Linux Management Administration Guide
®
Linux. This bundle allows you to use Preboot
397.
"ZENworks Management
Chapter 30,
Zone":
Advertisement
Table of Contents
Troubleshooting
